Filter
Top Products
22 C611M-C (3/06)
CONFIGURING ALERTS FOR AN EXTERNAL RAID NVR300
NOTE: The following information applies to external NVR300 RAID models only; and not to non-RAID models.
If a hard disk drive fails or a communication error occurs within an external RAID configuration, the NVR300 allows three types of default
notification to alert you of the failure or problem:
• RAID Manager Messages. These appear on the RAID Manager web page (access this page using the RAID Manager icon located on the
desktop) in case of failure of one or more storage components. These messages contain the error details. They cannot be controlled; that is,
they activate automatically.
• E-Mail Notifications. An e-mail server must be available and configured properly for this to work. Alert messages will be sent to an
e-mail address defined on the Email Setting tab in the RAID Manager Gateway Config menu.
• Net Send Event Notifications. These appear on the view station screen in case of failure of one or more storage components. These
messages also contain the error details. However, they can be controlled from the Event Notification window.
Do the following to configure the RAID Manager software.
1. Right-click the blue, red, and green flag icon in the task bar. A menu appears.
Figure 9. Raid Manager Gateway Config Selection Menu
2. Select RAID Manager Gateway Config. The ACSGateway Config. window appears.
Figure 10. ACSGateway Config
3. Click the Add Server button in the lower left corner. The Add Server panel appears.