Philips WV-NM100 Security Camera User Manual


 
30
SETUP
Basic Settings
After completing the network setup of the PC and the camera, begin the basic settings of the camera.
The basic settings are the minimum settings required to operate the camera, such as date setting and setting of
"Operation mode".
Begin the setup when the PC is in the same condition as just
after the startup.
The browser starts up. The web page set as the home page in
your browser appears.
(The picture is the page of the Panasonic web site.)
Screenshot 2
Screenshot 1
Start up Internet Explorer on your PC.
STEP1
Enter the IP address assigned by the
"Panasonic IP Setup" software in the "Address"
box of Internet Explorer. (If the IP address has
not been assigned yet, enter the default IP
address "192.168.0.10".)
You can confirm the assigned IP address by
pressing the [REFRESH] button in the
"Panasonic IP Setup" window.
If the broadband router is set to use the address
translation, enter [IP address + : (colon) + port
number] in the "Address" box, and press the
enter key.
Refer to page 17 about the IP address setting.
STEP2