Philips WV-NM100 Security Camera User Manual


 
7
PRECAUTIONS
Refer all work related to the installation
of this product to qualified service
personnel or system installers.
Do not operate the appliance beyond its
specified temperature, humidity, or
power source ratings.
Use the appliance at temperatures within 0 °C - +
40 °C (32 °F - 104 °F) and humidity below 90 %.
The input power source for this appliance is 120 V
AC 60 Hz.
Handle the appliance with care.
Do not strike or shake, as this may damage the
appliance.
Do not aim the camera at bright light
sources.
If a bright light, such as a spotlight, is present on
the monitor screen, blooming (blurring around
areas with excessive brightness) or smearing
(appearance of vertical lines above and below a
bright object) may occur.
Only use the camera indoors.
Do not install it in places where the camera is
exposed to sunlight for long periods of time or near
air conditioning equipment. This will cause defor-
mation, discoloration, breakdown or malfunction.
Only use the AC adapter provided with
this camera to connect to the power
source.
Do not plug it into an outlet also hosting big appli-
ances with high power consumption (such as a
copy machine or an air conditioning unit).
Do not touch the dome cover directly.
Dirt on the dome cover may decrease the quality of
the picture.
Hold it by its sides when you move the camera.
Do not strike or give a strong shock to
the camera.
It may cause damage or allow water to enter the
camera.
Built-in backup battery
Before the first use, charge the built-in backup bat-
tery by turning on the power for 48 hours or more.
If it is not charged enough, in the case where the
power goes down, the internal clock may keep bad
time or the operative condition may be different to
that before the electric power failure.
The built-in battery life is approximately 5 years.
Ask the shop where you purchased the camera
when replacement of the battery is required.
Cleaning
Turn the power off when cleaning the camera.
Otherwise it may cause injuries.
Do not use strong or abrasive detergents
when cleaning the appliance body.
Use a dry cloth to clean the appliance when it is
dirty.
When the dirt is hard to remove, use a mild deter-
gent and wipe gently.
To obtain clear images
Clean the dome cover approximately once a month
to obtain clear images.
PC monitor
Displaying the same image for a long time on the
monitor screen may damage the monitor screen. It
is recommended that a screen saver be used.
Broadband Router
If the camera is connected via the Internet with a
router, use a broadband router with address trans-
lation (NAT or IP masquerade). Refer to the operat-
ing instructions of the broadband router for the
description of the address translation.
Restart automatically when an error is
detected.
The camera restarts automatically when an error is
detected for any reason. You cannot operate the
camera for approximately two minutes after the
restart until the initialization has been completed,
as happens when the power is turned on for the
first time.
We recommend that you note down your
settings and save them. Power or battery
failure may erase the settings you
entered.