Philips WV-NM100 Security Camera User Manual


 
39
If the preset position is not registered, you cannot
add the preset position to "Preset tour".
If a preset name is not entered, you cannot select
the preset position. (Preset name cannot be clicked
as it does not appear in the "Preset" area.)
! Important
Monitoring the Picture of a Camera in a Preset Position
You can monitor both the still picture and the motion picture of a camera installed in a place registered as a preset
position.
To monitor the image of the camera in a preset position, adjusting the position of the camera (horizontal and vertical
position) and registering the shooting location, as a preset position is required in advance.
Registration of a preset position
Begin to register a preset position of the camera.
Register the preset number and preset name of a preset position.
Up to eight preset positions can be registered.
Begin the operation from the "Control" page.
The "Preset registration" area appears below the list of "Preset".
Screenshot 2
Screenshot 1
Click "Preset Setup".
STEP1
Click the arrow buttons (up / down / right / left) to
adjust the horizontal and vertical position of the
picture.
After the adjustment of the position has been
completed, select a preset number and enter a
preset name for the preset position. And then,
click the [SET] button.
Characters for the preset name: 1 character to
32 characters
Repeat STEP 2 to STEP 3 to register more pre-
set positions.
To add a registered preset position to "Preset
tour", check the box next to the desired preset
name. (Uncheck the box to delete it from "Preset
tour".)
Click the [SET] button after completing the set-
ting.
STEP4
STEP3
STEP2