Filter
Top Products
68
more on PhotograPhy
Macro Target Selection
If Macro Target is assigned to the Fn1
or Fn2 button (page 136), you can select
macro mode by pressing the assigned
button in shooting mode. The cross-
hairs shown at right will be displayed;
use the directional pad (page 37) to
position the cross-hairs over your
subject, and press C/D (to exit without setting the target,
press the DISP. button). Press the shutter-release button halfway to
focus on the selected target, and then gently press the shutter-
release button the rest of the way down to take the picture.
If the ADJ. lever has been used to select a focus target (page 66),
you cannot select macro target mode by pressing Fn1 and Fn2
until the target is canceled.
Snap Focus Distance
Select the distance at which the camera focuses when
Snap is selected for Focus (page 64) or Full Press Snap
is on (page 69). Choose from 1 m (3.3 ft.), 1.5 m (4.9 ft.),
2 m (6.6 ft.), 2.5 m (8.2 ft.), 3 m (9.9 ft.), 3.5 m (11.5 ft.), 5 m
(16.4 ft.), and ∞ (innity).
Note
When Snap is selected for Focus or Full Press Snap is on, the
snap focus distance can also be selected by rotating the up-
down dial while pressing the N button.