Filter
Top Products
Installing SCC-C6475(P)
Installation Precautions
1) Make sure that the installation site can sufficiently support a minimum of
four times the net weight of the SCC-C6475(P) IP SmartDome Camera
and other accessories.
2) Install in an area where the space above the ceiling board is over 18 cm
(7 in.) high.
3) Use the supplied screws to fasten the camera to the bracket assembly.
4) Keep persons away from the installation area, as there is a risk of falling
objects.
Also, move valuables to a safe location before installation.
Separately Sold Products for Installation
Depending on the installation site, it may be convenient to use one of the
following products.
1) CEILING MOUNT BRACKET
(SBR-100DCM)
This bracket is used for installing
the IP SmartDome Camera in the
plenum above the drop ceiling.
2) WALL MOUNT ADAPTOR
(SADT-100WM)
This adaptor is used for installing the
indoor housing or the outdoor
housing for the IP SmartDome
Camera on a wall.
2-5
E
2-4
6. Connect the Remote Control
Terminal of the
SCC-C6475(P)
and the external Controller.
Controller
Adapter BOARD
1. First, connect one end of the
BNC video cable connector to
the Video Output Terminal
(VIDEO OUT)
2. Then, connect the other end of
the connector to the Video Input
Terminal of the monitor.
3. Adjust the power select switch
(110 V or 220 V) after verifying
the power to connect SCC-
C6475(P).
4. Connect the two adapter power
output cables to the power input
terminal of SCC-C6475(P) by
using the setting driver.
5. Connect the LAN cable to the IP
router or hub to the using
NETWORK connect terminal.
Cable Connection