Filter
Top Products
4-4 4-5
E
1. CAMERA SET MENU
CAMERA ID
The CAMERA ID menu assigns an ID to the SCC-C6475(P) to be displayed
on the connected monitor.On the CAMERA SET menu screen, select
CAMERA ID to ON and press [Enter]. You will see the sub screen for
deciding on the ID of the SCC-C6475(P). The Camera ID can have up to
20 alphanumeric characters, along with several special characters.
The assigned camera ID may be positioned to any desired location on the
screen by using the LOCATION submenu.
Use the controller to press the MENU selection key and the following
screen will be displayed.
In case of
➀
, use UP/DOWN/LEFT/RIGHT/[ENTER] key for MENU
setup. In case of
➁
, type in the 4 digit password first. If correct, the
MENU selection screen like
➀
will be displayed and you will be able to
set up MENU by pressing UP/DOWN/LEFT/RIGHT/[ENTER] key.
* * MAIN MENU * *
CAMERA SET...
VIDEO SET...
PRESET ...
ZONE SET...
AUTO SET...
ALARM SET...
OTHER SET...
SYSTEM INFO...
0 1 2 3 4
5 6 7 8 9
➀
PASSWORD
UNDEFINED
➁ PASSWORD
DEFINED
✽ ✽ ✽ ✽
❈
If the power is turned off after PRESET, AUTO PAN, SCAN,
PATTERN function is activated and no other control is made, camera
will do the same function after the power is turned on.
❈
Menu setting is available only when tilt position is under 90°.
When tilt position is over 90° and menu-on command is received,
pan will automatically rotate 180° and tilt will be move to the
corresponding position.
➜
Press
[Enter]
(CAMERA SET)
CAMERA ID OFF
V-SYNC LINE...
COLOR/BW COLOR
MOTION DET OFF
ZOOM SPEED 3
DIGITAL ZOOM OFF
EXIT QUIT
➜
Press
[Enter]
* " ... " Means there are Sub Menus.
(CAMERA SET)
CAMERA ID ON...
V-SYNC INT
COLOR/BW COLOR
MOTION DET OFF
ZOOM SPEED 3
DIGITAL ZOOM OFF
EXIT QUIT
(CAMERA ID)
A B C D E F G H I J K L
M N O PQ R S T U V W X
Y Z 0 1 2 3 4 5 6 7 8 9
: ! - + ✽ ( ) /
SP
ï î
SP
LOCATION...
RET
SCC-C6475(P)........
V-SYNC
In the V-SYNC menu, vertical synchronization can be selected. The
vertical synchronization signal supported by the SCC-C6475(P) is the INT
mode made by clock inside the SCC-C6475(P) and LINE mode adjusting
vertical synchronization to the exterior power frequency.
Select LINE and press [Enter]. You will see the LINE LOCK submenu
where you can adjust the phase of the LINE LOCK.
You can use the PHASE menu of the LINE LOCK submenu to assign as
much PHASE as you want.
(LL-PHASE)
PHASE (000)----
I ----
RET
CC
CC
aa
aa
uu
uu
tt
tt
ii
ii
oo
oo
nn
nn
CAMERA ID OSD is not displayed in the network viewer.