Filter
Top Products
4-25
E
DIRECTION
This sets up the movement direction of the START to END location
(PAN location standard)
"RIGHT " : "LEFT " :
ENDLESS
This is a 360-degree rotation function that stops for the DWELL TIME only in the
START and END positions without running between the START and END
positions. It can be set to "ON" or "OFF".
SPEED
This is a setting function for movement speed setup. It can be set from
STEP1 to STEP64.
DWELL TIME
This is a function for setting up the time to stay in the START to END position.
PATTERN
This is a replay function so that the MANUAL functions such as PAN, TILT,
ZOOM, and FOCUS are played for 2 minutes.
4-24
PATTERN SET 1
➜
After PATTER
START
position setup,
press
[ENTER].
➜
Press
[Enter]
➜
Press
[Enter]
* * MAIN MENU * *
CAMERA SET...
VIDEO SET...
PRESET...
ZONE SET...
AUTO SET...
ALARM SET...
OTHER SET...
SYSTEM INFO...
(AUTO SET)
AUTO PAN 1...
PATTERN 1...
SCAN 1...
AUTO PLAY ...
RET
➜
Press
[Enter]
(AUTO SET)
AUTO PAN 1...
PATTERN 1...
SCAN 1...
AUTO PLAY ...
RET
PATTERN SET 1
SET START POSITION
AND ENTER
PATTERN can be set upto 3. Choose 1, 2, or 3 with the left or right key in the
"PATTERN SET" and press [ENTER] to get into the PATTERN set up screen. From
the moment "PATTERN 1 SET" is gone for 2 minutes, it memorizes the MANUAL
movements and after 2 minutes it will return to a higher menu. If you want to finish
set up before the 2-minutes ends, press [ENTER].
If you enter the SCAN SET screen, PRESET MAP will be displayed. Move the
cursor to the number marked * where PRESET is saved and press [ENTER] and
S will appear and a PRESET will be included in SCAN.
SCAN
SCAN sets the direction of PRESET movement during “SCAN” operation. The
number of SCAN is up to 4 and each SCAN is able to allocate 32 PRESETs as a
maximum.
SCAN MAP 1
0*S 1* 2 3 4
5 6 7 8 9
10 11 12 13 14
15 16 17 18 19
20 21 22 23 24
25 26 27 28 29
30 31
î ï
EXIT SAVE
❈ When the PATTERN is saved/executed, the PAN/TILT is operated with
PROPORTIONAL ON, TURBO OFF.
❈ Two minutes PATTERN function is supported only by the ALARM VER
1.100 over. If the SSC-1000 or SSC-2000 is used when
uploading/downloading the menu setup, reset the PATTERN because it
may be different with the first setting.