Filter
Top Products
Netcam(W)_SNC-L200(W)
87
Netcam(W)_SNC-L200(W)
86
Using the MultiViewer
Recording Motion
Click the video you want to
motion-record on the MultiViewer
Screen.
Click the Motion Button( ).
-
The Motion Record Screen
appears.
Click the Motion area in the
16-split screen.
- The motion area is displayed in
green color.
- Click the button again to clear the
motion area.
Enter the Sensitivity Value.
- Enter a value between 1 and
10.The level of sensitivity
increases close to 10.
Click the Pretest Button.
- The Sensitivity Setting Value is
temporarily stored.
- When a motion is detected, the
motion area turns red, and
blinks.Testing starts.
Set the motion area in the 16-split video, and automatically record video when a
motion is detected in the set area. This function is applied to only one channel.
The motion area turns red, and blinks. Recording starts automatically.
- The REC-A is displayed on the screen, and video is recorded for up to 10 minutes.
When a motion is detected in the motion area
Set the most appropriate value by
repeating the step 3 to 5.
Click the “Enable Motion Detection” to
display the motion detection.
- The motion detection is selected.
- To clear the motion detection, click the
button again and clear the display.
Click the OK Button.
- Settings are completed.
The Motion Detection detects and records a motion, while the PIR
detects infrared.
Note
1
3
5
4
2
3
4
5
6
7
7 8
8