Filter
Top Products
Chapter 4 Scene Selection
71
4-3 Clip List Operations
The sub clip deletion screen appears.
To cancel the deletion, and escape from the sub clip
deletion screen
Do either of the following.
• Select CANCEL, and press the SEL/SET dial or the
MENU knob.
• Press the RESET button.
The screen returns to the sub clip thumbnail display.
3
Use the SEL/SET dial or the MENU knob to select
OK, and press the dial/knob.
This deletes the sub clip, and the screen returns to the
sub clip thumbnail display.
Saving edited clip lists to disc
The operations described above (moving, trimming, and
deleting sub clips) are carried out on the current clip list.
Execute the procedure in 4-3-2 “Saving the Current Clip
List to Disc” (page 71) to save the current clip list to disc
again as a clip list.
Note
Unless the current clip list has been saved to disc, its
contents will be lost when the camcorder is powered off or
the disc is ejected. After creating a clip list, be sure to save
it.
4-3 Clip List Operations
4-3-1 Displaying the CLIP Menu
Proceed as follows.
Note
The CLIP menu can handle up to 99 clip lists.
With the thumbnail indicator off, hold down the SHIFT
button and press the SUB CLIP button.
The CLIP menu appears.
Notes
• If the MENU ON/OFF switch is set to ON, set it to OFF,
then press the SUB CLIP button with the SHIFT button
held down.
• If you set the MENU ON/OFF switch to ON while the
CLIP menu is being displayed, thumbnail display is
cancelled and replaced with menu display.
Use this menu to carry out the following operations.
• Save the current clip list to disc.
• Load a clip list on disc into the current clip list.
• Delete a clip list from disc.
• Clear the current clip list.
• Set the start time code of the current clip list.
4-3-2 Saving the Current Clip List to
Disc
Proceed as follows.
1
Use the SEL/SET dial or the MENU knob to select
SAVE in the CLIP menu, and press the dial/knob.
A list of clip lists appears.
“NEW FILE” is shown for lists which do not exist on
the disc, having names only.
<CLIP MENU>
LOAD
SAVE
DELETE
CLEAR
TC PRESET