Filter
Top Products
39
Playback – Basics
You can monitor the recorded tape on the LCD screen. If you close the LCD panel, you
can monitor the playback picture in the viewfinder. You can also control playback using
the Remote Commander supplied with your camcorder.
(1) Set the POWER switch to VCR while pressing the small green button.
(2) Press OPEN to open the LCD panel.
(3) Press
to rewind the tape.
(4) Press
to start playback.
(5) Adjust the volume following the steps below.
1 Press FN to display PAGE1.
2 Press VOL. The screen to adjust the volume appears.
3 Press – (to turn down the volume)/+ (to turn up the volume).
4 Press
OK to return to PAGE1.
To return to FN
Press EXIT.
To stop playback
Press in the stop state.
To rewind the tape
Press in the stop state.
To fastforward the tape
Press in the stop state.
To view a still image (playback pause)
Press during playback. To resume playback, press again. When playback
pause lasts for about five minutes, your camcorder automatically enters the stop state.
If you leave the power on for a long time
Your camcorder gets warm. This is not a malfunction.
— Playback – Basics —
Playing back a tape
4
3
1
5
2
VOL
–+
OK
VCR
MEMORY/
NETWORK
CAMERA
OFF(CHG)
POW
E
R
The bar indicator