Filter
Top Products
Advanced Operations
45
GB
Flash compensation
When the flash unit is in a flash mode that supports TTL metering, the flash
intensity is automatically adjusted. However, you can correct this automatically
adjusted flash intensity.
• Flash modes that support TTL metering
– TTL mode
– WL CTRL mode when [TTL RATIO: ON] or [RATIO: OFF] is set
• In flash modes that support TTL metering, the flash compensation indicator
appears at the bottom right of the normal indicator screen.
• Does not work with a camera that has an Auto-lock Accessory Shoe.
See online for compatible camera models. (Even with a non-compatible camera,
the flash compensation is shown when communication with the camera is off.
Even in this case, when communication with the camera is restarted the flash
compensation indicator disappears and flash compensation is not carried out.)
• When using the flash unit with an off-camera cable (page 84), the power level
itself is corrected but the value of the correction on the flash is not reflected in
the Exif data of the camera.
• If metering is corrected on both the flash unit and the camera, the flash fires
according to the sum of both values. However, the LCD panel of the flash unit
only shows the correction value set on the flash.
1 Press the control wheel left ( ).