Filter
Top Products
Advanced Operations
93
GB
Setting the recording mode to enable manual flash (M) or
multiple flash photography [MANUAL MODE]
Setting values: MANUAL, PASM
• When [MANUAL] is selected, the flash unit can perform manual flash and
multiple flash only in the camera's M (manual) mode.
• When [PASM] is selected, manual flash photography and multiple flash
photography may be used in all recording modes of your camera. The proper
exposure may not be obtained with photography in modes other than the M
mode of your camera, therefore we recommend the M mode of your camera.
• When [PASM] is selected, this flash unit remains in manual flash mode even if
the recording mode of the camera is changed to AUTO (automatic mode).
• Depending on the camera's flash mode, you may only be able to select flash off.
Check the operating instructions of your camera too.
Setting the test flash mode [TEST]
Setting values: 1 TIME, 3 TIMES, 4 SEC
[1 TIME] : flashes once at the set light level.
[3 TIMES] : flashes three times at a specific rate.
[4 SEC] : flashes for four seconds at a specific rate.
Setting the time until power save [POWER SAVE]
Setting values: 30 SEC, 3 MIN, 30 MIN, OFF
[30 SEC] : changes to power save mode after 30 seconds.
[3 MIN] : changes to power save mode after 3 minutes.
[30 MIN] : changes to power save mode after 30 minutes.
[OFF] : disables power save mode.