Filter
Top Products
Chapter 7 Menu Displays and Detailed Settings
143
7-4 Resetting USER Menu Settings to the Standard Settings
10
Repeat steps 3 to 6 to set the default gateway.
11
To end the menu operation, set the MENU ON/OFF
switch to OFF.
Setting the communications speed
Set the communications speed by choosing AUTO,
10Mbps, or 100Mbps from the menu.
The factory default setting is “AUTO”.
Proceed as follows.
1
Carry out steps 1 to 3 in “Enabling automatic
acquisition of the IP address” (page 142) to display
the NETWORK page of the MAINTENANCE menu.
2
Turn the MENU knob to move the b mark to “LINK
SPEED”, then press the MENU knob.
3
Turn the MENU knob to move the b mark to the
desired value, then press the MENU knob.
4
To end the menu operation, set the MENU ON/OFF
switch to OFF.
Setting the communications mode (full
duplex or half duplex)
Set the communications speed by choosing AUTO, FULL
(full duplex) or HALF (half duplex) from the menu.
The factory default setting is “AUTO”.
Proceed as follows.
1
Carry out steps 1 to 3 in “Enabling automatic
acquisition of the IP address” (page 142) to display
the NETWORK page of the MAINTENANCE menu.
2
Turn the MENU knob to move the b mark to
“DUPLEX”, then press the MENU knob.
3
Turn the MENU knob to move the b mark to the
desired mode, then press the MENU knob.
4
To end the menu operation, set the MENU ON/OFF
switch to OFF.
7-4 Resetting USER
Menu Settings to the
Standard Settings
You can return all settings in the USER menu to the
standard settings. It is also possible to change the standard
settings from their factory default values.
For details on how to change the factory settings, refer to
the Maintenance Manual.
Proceed as follows.
1
Set the MENU ON/OFF switch to ON.
The last accessed menu appears on the screen.
2
Turn the MENU knob until the USER FILE page
appears, and press the MENU knob.
The USER FILE page appears.
USER FILE page
3
Turn the MENU knob to move the b mark to “USER
PRESET”, and press the MENU knob.
The message “LOAD OK? YES b NO” appears.
4
Turn the MENU knob to move the b mark to”YES”,
and press the MENU knob.
The settings for all items in the USER menu are reset
to the standard settings.
U16 USER FILE
USER FILE LOAD : EXEC
USER FILE SAVE : EXEC
F.ID :
sssssssssssssssss
USER PRESET : EXEC
U16 USER FILE
LOAD OK? YES NO
USER FILE LOAD : EXEC
USER FILE SAVE : EXEC
F.ID :
sssssssssssssssss
USER PRESET : EXEC