Filter
Top Products
Chapter 10 Maintenance
176
10-3 Operation Warnings
1) “**” indicates the bit rate (50/40/30).
2) REC INHI.! appears if you attempt to start recording.
Phenomena specific to CCD image
sensors
The following phenomena that may appear in images are
specific to CCD (Charge Coupled Device) image sensors.
They do not indicate malfunctions.
White flecks
Although the CCD image sensors are produced with high-
precision technologies, fine white flecks may be generated
on the screen in rare cases, caused by cosmic rays, etc.
This is related to the principle of CCD image sensors and
is not a malfunction.
The white flecks especially tend to be seen in the following
cases:
• when operating at a high environmental temperature
• when you have raised the master gain (sensitivity)
• when operating in Slow-Shutter mode
This product has a compensation function and the problem
may be alleviated by automatic black balance adjustment
(see page 84).
Vertical smear
When an extremely bright object, such as a strong spotlight
or flashlight, is being shot, vertical tails may be produced
on the screen, or the image may be distorted.
Aliasing
When fine patterns, stripes, or lines are shot, they may
appear jagged or flicker.
KEY INHI.!
2)
Disc operations are not possible when the
DC IN connector is not connected and the
CA-755 is being used.
ILL. PLAY An A/V phase error occurred during
playback. Stop the disc.
Lid Closed! The lid of the disc compartment does not
open. Check the lid.
Lid Open! The lid of the disc compartment is not
closed. Close it securely.
No Clip! There are no clips recorded on the disc.
Exchange for a recorded disc.
No Disc! There is no disc loaded. Insert a disc and
try the operation again.
STOP ONCE!
REC mode!
The operation is not possible while the disc
is being played or recorded. Stop the disc.
Disc Top!
Disc End!
The operation is not possible because the
disc is at the top or end.
Formatting! The disc is being automatically formatted.
Wait until the format ends.
Live Logg! The operation you attempted is not
possible in Live Logging mode.Turn Live
Logging mode off and try again.
Recording The unit is writing to the file system. Wait
until writing finishes.
No EM Space
EM Full!
Essence marks cannot be inserted. For
details, see 3-2-3 “Recording Essence
Marks” (page 42).
SB CLP mode Try the operation again after pressing the
SUB CLIP button to turn off the sub clip
indicator.
No SEL List No clip list is selected. Create a new clip
list, or load a clip list from the disc.
No List! There is no clip list. Create a clip list.
No SUB Clip There are no sub clips in the clip list.
Register a sub clip, or load another clip list.
SUB Clip NG The In and Out point positions are invalid.
Set correct In and Out points.
MAX# SB CLP The total number of sub clips is over the
upper limit (300).
CL OVER DUR The total duration of sub clips in the current
clip list is over the upper limit (24 hours).
FAN Stopped!
DR-FAN Stop
The main unit or drive fan has stopped.
Avoid use under high temperatures, turn
off the power, and contact a Sony service
representative.
MEM REC NG! (only when CBK-PC01 is installed)
Proxy data recording failed because the
memory card ran out of memory.Exchange
the memory card, and copy the proxy data
that could not be recorded.
Message Meaning and action to take
Vertical tails shown on the
image.
Monitor screen
Bright object (e.g. strong
spotlight, strong reflected
light, flashlight, the sun)