Filter
Top Products
Appendixes
196
Menu List
06 AUDIO-1 CA-701 AUDIO IN ENABL/DSABL ENABL When a CA-701 camera adaptor is
connected, selects whether or not to enable
input of audio channels 3 and 4 from the
camera adaptor.
ENABL: Camera adaptor can be used.
DSABL: Camera adaptor cannot be used.
AUDIO CH3/4
MODE
CH1/2/SW SW Selects the sources to be recorded to
channels CH-3/4.
CH1/2: Same sources as CH-1/2.
SW: Signals selected by the AUDIO IN CH-3/
CH-4 switches.
REAR XLR AUTO OFF/ON OFF Turns the XLR connection automatic
detection on or off.
FRONT MIC REF –60 dB/–50 dB/
–40 dB
–60 dB Sets the reference level of the front
microphone.
REAR MIC REF –60 dB/–50 dB/
–40 dB
–60 dB Sets the reference level when the AUDIO IN
CH1 connector is set to MIC.
MIN ALARM VOL OFF/SET OFF Volume of the monitor speaker alarm tone
when it is turned all the way down.
OFF: Almost inaudible.
SET: Faintly audible.
SP ATT LEVEL OFF/3/6/9 dB OFF Lowers the volume of the monitor speaker.
Has no effect on earphone volume.
HEADPHONE OUT STREO/MONO MONO Selects whether to make the rear earphone
monaural or stereo.
07 AUDIO-2 AU DATA LEN (IMX)
(PDW-530/530P
only)
16 bit//24 bit 16bit Sets the bit length of the digital audio
recording.
AU REF LEVEL –20 dB/–18 dB/
–16 dB/–12 dB/
EBUL
–20 dB Sets the reference level (Head Room).
AU REF OUT EBUL/0 dB/+4 dB/
–3 dB
0 dB Sets the output reference level.
AU CH12 AGC
MODE
MONO/STREO MONO Selects whether to perform automatic input
level adjustment of analog audio signals to
be recorded on channels 1 and 2
independently for each channel, or in stereo
mode.
AU CH34 AGC
MODE
MONO/STREO/
OFF
MONO Selects whether to perform automatic input
level adjustment of analog audio signals to
be recorded on channels 3 and 4
independently for each channel, or in stereo
mode, or not at all (OFF).
AU AGC SPEC –6/–9/–12/–15 dB –6 dB AGC saturation level setting
AU LIMITER MODE OFF/–6/–9/–12/
–15/–17 dB
OFF For manual audio input level adjustment,
selects the limiter saturation level for loud
input signals.
AU OUT LIMITER OFF/ON ON Turns the audio output limiter on or off.
i.LINK AUDIO OUT 2CH/4CH 2CH 2CH: Output channels 1 and 2 (16 bits, 48
ksps)
4CH: Output channels 1 to 4 (12 bits, 32
ksps)
No. Page Item Settings Default Description