Filter
Top Products
External Synchronization
142
Connecting External Devices
Thus the built-in timecode generator of your
camcorder locks to the reference timecode.
The message “EXT-LK” is displayed on the
screen.
After about 10 seconds, you can disconnect the
external timecode without losing the
synchronization.
Notes
• Check that the reference timecode and the
reference video signal are in a phase relation
that complies the SMPTE timecode standards.
• When you finish the above procedure, the
timecode is immediately synchronized with the
external timecode, and the time data indication
will show the value of the external timecode.
However, wait for a few seconds until the
timecode generator stabilizes before recording.
• If the frequency of the reference video signal is
not the same as the frame frequency of the
camcorder, the camcorder cannot be correctly
genlocked. In such a case, the timecode is not
correctly synchronized with the external
timecode.
• When the connection is removed, the timecode
advance may shift one frame per hour with
respect to the reference timecode.
To release the external timecode
synchronization
Change the “Timecode” setting of the TC/UB
SET menu or turn off the camcorder.
External synchronization is also released when
you start recording in a special recording mode
(Slow & Quick Motion, Frame Rec, or Interval
Rec).
Synchronizing the timecode of another
unit with that of your camcorder
The timecode of another unit can be locked to that
of your camcorder.
1 Specify the timecode of your camcorder
with “Timecode” and “TC Format” (see
page 53).
2 Connect the TC OUT connector and
VIDEO OUT connector with the
timecode input and reference signal
input of the other unit, respectively.
The timecode to be output from the TC OUT
connector depends on the setting of “TC Out” on
the TC/UB SET menu. If “TC Out” is set to
“Generator,” the timecode generated by the
timecode generator of the camcorder is output
during recording and playback. If “TC Out” is set
to “Auto,” the timecode generated by the
timecode generator is output during recording,
and that superimposed with the video signal is
output during playback.
GENLOCK IN
TC IN
75-ohm
coaxial cables
(optional)
Reference
timecode
Reference
video signal
TCG 00:00:00:00
H
Q
1080/23.98P
EXT-LK
T
BY
S&
Q
STBY
VIDEO
OUT
TC OUT
To the timecode
input of the other
unit
To the reference
video input of the
other unit
75-ohm coaxial
cables (optional)