Filter
Top Products
The CHG (Charge) lamp goes out when charging is completed.
The charging time
*1
of the battery pack on the remote control is as follows.
Via a computer: Approx. 4 h 05 min.
Via an AC-UD10
*2
: Approx. 2 h 55 min.
*1
Time required to charge a fully depleted battery pack at a temperature of 25°C (77°F). Charging may
take longer under certain circumstances or conditions.
*2
Rapid charging is possible using the USB charger AC-UD10 (sold separately). To connect to the
charger, use the micro USB cable (supplied).
Note
You can charge the remote control even if it is not completely discharged. Also, even if the
remote control is not fully charged, you can use the partial charge capacity of the battery
pack as is.
When the power of the remote control is on, it is supplied with power but not charged.
To maintain the remote control’s function, fully charge the remote control, and then fully
discharge it at least once a year while storing. And keep the remote control in a cool place
with low humidity.
Hint
Checking the remaining battery charge
A remaining charge indicator appears on the upper right of the LCD screen.
The displayed remaining charge indicator may not be correct under certain
circumstances.
It takes about 30 seconds until the correct remaining charge indicator appears.
If the battery pack runs out quickly even though the remaining charge indicator is high,
fully charge the remote control, again. The remaining charge indicator will then be
displayed correctly. Note that it may not be displayed correctly in a situation where the
remote control is used for a long time at high ambient temperature or the remote control is
left fully charged.