Filter
Top Products
Administrating the Camera
Configuring the Network — Network setting Menu
39
Setup Program, access the camera again by typing the IP
address of the camera on your Web browser as follows:
Example: when HTTP port number is set to 8000
OK/Cancel
See “Buttons common to every setting menu” on page
29.
PPPoE Tab - Setting of PPPoE
Connection
Use it when you connect the camera with PPPoE (Point-
to-Point Protocol over Ethernet). PPPoE connection is
the protocol that is widely used in xDSL (digital affiliate
line such as ADSL, VDSL or SDSL) as the
authentication and connection system.
PPPoE
Set whether you connect the camera using PPPoE
function or not. When On is selected, PPPoE connection
is used.
IP address
When you connect to the network by PPPoE function, IP
address obtained at PPPoE connection is displayed.
User ID
Type the user ID for the authentication necessary for
PPPoE connection. Type up to 64 characters.
Password
Type the password for the authentication necessary for
PPPoE connection. Type comfirm from 1 to 32
characters.
Re-type password
To comfirm the password, re-type the password typed in
the password box.
Obtain DNS server address automatically
Select to obtain the address of DNS server
automatically.
Use the following DNS server address
Select to set the fixed address as the IP address of DNS
server.
Primary DNS server
Type the IP address of the primary DNS server.
Secondary DNS server
Type the IP address of the secondary DNS server, if
necessary.
OK/Cancel
See “Buttons common to every setting menu” on page
29.
Dynamic IP address notification
Tab — Notifying the IP Address
When the DHCP setting is set to On or PPPoE setting is
set to On on the Network tab, you can send notification
of the completion of the network settings using the
SMTP or HTTP protocol.