Filter
Top Products
Administrating the Camera
Sending an Image via mail — e-Mail (SMTP) setting Menu
44
SMTP server name
Type the SMTP server name up to 64 characters, or the
IP address of the SMTP server.
Authentication
Select the authentication required when you send an e-
Mail.
None: Select if no authentication is required when an e-
Mail is sent.
SMTP authentication: Select if authentication is
required when an e-Mail is sent.
POP before SMTP: Select if POP before SMTP
authentication is required when an e-Mail is sent.
POP server name
It is necessary when the POP before SMTP is selected
in Authentication.
Type the POP (receiving mail) server name up to 64
characters, or type the IP address of the POP server. This
setting is necessary when the SMTP server which sends
e-mails performs authentication using the POP user
account.
User name, Password
Type the user name and Password of the user who has
the mail account. This setting is necessary when the
SMTP server which sends e-mails performs
authentication.
Recipient e-Mail address
Type the recipient e-Mail address up to 64 characters.
You can specify up to three recipient e-Mail addresses.
Administrator e-Mail address
Type the Administrator e-Mail address up to 64
characters.
This address is used for reply mail and sending system
messages from the SMTP server.
Subject
Type the subject/title of the e-Mail up to 64 characters.
When Alarm sending of the alarm tab is set to ON, the
mail sent due to the alarm detection will indicate the
type of alarm in the subject. [SI] is added for sensor
input detection, and [MD] is added for motion detection.
Message
Type the text of the e-Mail up to 384 characters. (A line
break is equivalent to 2 characters.)
OK/Cancel
See “Buttons common to every setting menu” on page
29.
Alarm sending Tab — Setting the
mail sending mode when detecting
the alarm
Set to send the mail with connection to the alarm
detection by the external sensor input or by the built-in
motion detection function.
Alarm sending
Select On to set to send mail with connection to the
alarm detection.
File attachment
Set whether an image file is to be attached to the mail or
not.
When On is selected, the image file made by the settings
below is attached. When Off is selected, only the
message is sent.
Image file name
Type the file name you want to assign to the image to
attach a mail. You can use up to 10 alphanumeric, -
(hyphen) and _ (underscore) for naming.
Suffix
Select a suffix to add to the file name.
None: No suffix is added. The Image file name is
assigned to the image to be sent via an e-Mail.
Date & time: The date & time suffix is added to the
Image file name.
The date/time suffix consists of lower two-digits of
year (2 digits), month (2 digits), date (2 digits), hour
(2 digits), minute (2 digits), second (2 digits), and
consecutive number (2 digits), thus 14-digit number
is added to the file name.
Sequence number: A consecutive number of 10 digits
between 0000000001 and 4294967295 and two fixed
digits 00 is added to the Image file name.