Sony SNP-3350 Security Camera User Manual


  Open as PDF
of 53
 
NETWORK PTZ CAMERA User Guide
48
NETWORK PTZ CAMERA User Guide
49
Chapter 4. Using Web Viewer
•Dependingonthetypeofvideo,enteranaddressasfromtheexamplesinthefollowing
chart, and then click Play (P). (When using the default RTSP port number, 554, you may
skip entering the port number.)
The followings are examples of addresses for network streaming.
Address Streaming Engine Settings
rtsp://<IP>:<SERVICE PORT>/mpeg4unicast For RTSP/TCP and RTP/UDP
rtsp://<IP>:<SERVICE PORT>/mpeg4multicast For RTSP/Multicast
<IP> : The current camera IP
<Service Port> : The number of the service port +1 that is selected at the
Config Setup
→
Network menu.
ex) default port : 80
→
<SERVICE PORT> : 81
※
When using the default RTSP port number, 554, you may skip entering
the port number.
Notes
•Newsettingsaresavedonlyifyouclickthe button at the bottom of the screen.
Apply The button cancels new settings.
Caution
4.2.1.3 Motion Detection
Configure the camera’s Motion Detection operation.
Category Description
Enable Check to enable Motion Detection.
Sensitivity
Select a sensitivity level for motion detection according to the video display
settings. 5 levels are available, and 5 is the most sensitive.
: Selected Area,
: Other Areas.
Notes
 previous next