Filter
Top Products
© Copyright 2014 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TV-IP302PI
18
4.
According to the certificate source, there are two ways to install the certificate.
If you had sent the certificate request to do sign and received a signed
certificate, please click” browse” and find the certificate file in your
computer. Click “Apply” to install it.
If you choose to generate a self-signed certificate, fill in the following forms
and set validity day, click “Apply” to finish installed it.
After finishing installation, you can click “Content” to call out and check the
certificate content.
5.
To use Https to access camera, open your browser, and key in "https://(IP
address)/" in the address bar. Now your data will be transmitted via encrypted
communications, and the browser will check your certificate status. If it shows
you a warning message. The warning message meant that the certificate is self-
signed or signed by distrusted institution. Click Continue to this website to view
the view the camera.
Network >> Advanced >> SNMP
SNMP (Simple Network Management Protocol) provides a simple framework for
administering networked hardware. To manage the IP camera, you have to prepare a
MIB browser or similar tools first. SNMPv1, SNMPv2c, and SNMPv3 can be enabled
simultaneously.
The following examples are based on MG- SOFT MIB Browser. Depending on your
MIS Browser, you may see different interface and options. Please refer to the user
manual of your MIB Browser.
SNMPv1 and SNMPv2:
The term "Community name" in SNMPv1 and SNMPv2c can be roughly regarded
as key. The person who has the community name has the authority to read or
edit the information of IP camera via SNMP.
Click the box to enable SNMPv1 or SNMPv2c protocol, and specify the
community name for write (read and write) and read (read-only). The user who
use read community name to access the IP camera cannot modify any data of
the camera. The community name can be any English characters and numbers,
and must be shorter than 31 bits.