Filter
Top Products
© Copyright 2014 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TV-IP302PI
19
SNMPv3:
For data security reason, the authentication and encryption assurances are
added when developing SNMPv3. The user has to give not only the security
name(similar with "community name" in v1&v2c) but the password in order to
access the IP camera. Please set security name, authentication type,
authentication password, encryption type, encryption password of write and
read respectively. The security name can be any English characters and numbers,
and must be shorter than 31 characters. The password must between 8 to 64
characters.
Different from in SNMPv1 and v2c, the user have to create an account when
using SNMPv3. In the account parameters, key in the security name and
password you set in the camera to get accessing.
.
SNMPv1/SNMPv2 Trap:
Trap is a mechanism that allows a managed device to send messages to manager
instead of waiting passively for polling from the manager. Specify the trap event.
When those events happen, the camera will send the ring message to the Trap
Address, which is usually the manager's IP address. Trap Community means the
community that can receive the trap message.
Note: Trap Address must be under the same LAN with IP camera.
Cold Start: The camera starts up or reboots.
Setting changed: The SNMP setting is changed.
Network Disconnected: The network connection was broken down. (The
camera will send trap messages after the network being connected again)
V3 Authentication Failed: A SNMPv3 user account tries to get
authentication but failed. (Due to incorrect password or community)