Filter
Top Products
© Copyright 2014 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TV-IP302PI
32
Please connect the GND & DI pin to the external trigger device.
If you select "N.O" in "Input sensor setting", when external devise or circuit
makes DI and GND pin connected, the camera input alarm is triggered, and
then camera will execute the action user has set, for example, send snapshot
to E-mail address.
If you select "N.C" in "Input sensor setting", when external devise or circuit
makes DI and GND pin disconnected, the camera input alarm is triggered,
and then camera will execute the action user has set, for example, send
snapshot to E-mail address.
GPIO PIN definition
GND (Ground): Initial state is LOW
DO (Digital Output): DC 5V
DI (Digital Input): Max. 50mA, DC 5V
2.
GPIO Setting
Event Configuration >> GPIO Setting >> Input Setting
Input Sensor: According to your external device and circuit design, select
N.O (normally open) or N.C (normally closed).
Input Action: When the camera input alarm is triggered, it can trigger the
relay out, or send the video to E-mail/ FTP/ SAMBA.
Interval: If you select "10 sec" here, once the input alarm is detected and
action is triggered, it cannot be triggered again within 10 seconds.
Based on the schedule: When click the option box, only during the selected
schedule time the I/O is enabled. That is, for example, the 11th hour of
Monday has not been colored in the schedule table, then no action will be
triggered even the camera detects input signal during 11:00~12:00 on
Monday.
Event Configuration >> GPIO Setting >> Output Setting
Mode Setting
On/Off Switch:
When event happens, the camera triggers the external devise and lasts
for certain of time according to the event "interval" setting. If it's
triggered by motion detection, the triggering time is according to
"interval" setting of motion detection. If it's triggered by external input
alarm, the triggering time is according to input "interval" setting. It
triggers the external devise and lasts for 10 seconds if you select "10" in
interval setting. You can turn off the alarm manually by click "off" at the
bottom-right of the live screen page.
Time Switch:
When event happens, the camera triggers the external devise and lasts
for certain of time according to the output "interval" setting, and the
user is not allowed to break off the alarm manually.
3.
Output Test
After the external output hardware is installed, you can use the "Relay Out"
button on the live video page to test if DO device works.
On/Off Switch mode:
Click "ON", the camera will trigger the external output devise. For example,
your alarm buzzer will continuously ring. You can manually break off the
output signal by clicking "OFF".