Filter
Top Products
© Copyright 2014 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TV-IP302PI
33
Time Switch mode:
Click "Pulse", the camera will trigger the external output devise for several
seconds. The duration length is according to the "interval" setting in Output
Setting.
Event Configuration >> Logs
Click "Logs" to see System Logs, Motion Detection Logs, GPIO Logs and All Logs. If
you remove the power from IP camera, Motion Detection Logs will be cleared away.
Factory Default
If you forget your password, please follow the steps to revert back to default value.
1.
Remove the power and network cable.
2.
Take the included Reset Wire Cable, plug one side of the wire into "Default" and
the other side into "GND" on the terminal block as the picture below.
3.
Connect power to the camera again. It takes around 30 seconds to boot the
camera.
4.
Remove the wire and plug in the network cable after the camera finishes
booting.
5.
If your camera is under a DHCP server, DHCP server will assign an IP
automatically. Use IP Installer to find it. If you do not have a DHCP server, the
default IP address of camera is 192.168.10.30. Default username is "admin" and
password is "admin".