Filter
Top Products
VIP X1600 M4S Configuration Using a Web Browser | en 33
Bosch Security Systems Installation and Operating Manual DOC | V4.0 | 2009.06
5.10 Advanced Mode: Identification
Device ID
Each module should be assigned a unique identifier that you can enter here as an additional
means of identification.
Device name
You can give the module a name to make it easier to identify. The name makes the task of
administering multiple units in larger video monitoring systems easier, for example using the
VIDOS or Bosch Video Management System programs.
The device name is used for the remote identification of a module, in the event of an alarm for
example. For this reason, enter a name that makes it as easy as possible to quickly identify the
location.
Camera 1 to Camera 4
The camera name makes it easier to identify the remote camera location, in the event of an
alarm for example. It will be displayed in the video screen if configured to do so (see
Section Camera name stamping, page 37). The camera name makes the task of administering
cameras in larger video monitoring systems easier, for example using the VIDOS or Bosch
Video Management System programs.
Enter a unique, unambiguous name for the camera in this field. You can use both lines for this.
!
CAUTION!
Do not use any special characters, for example &, in the name.
Special characters are not supported by the system's internal recording management and may
therefore result in the Player or Archive Player being unable to play back the recording.
!
CAUTION!
Do not use any special characters, for example &, in the name.
Special characters are not supported by the system's internal recording management and may
therefore result in the Player or Archive Player being unable to play back the recording.