Filter
Top Products
VIP X1600 M4S Operation | en 93
Bosch Security Systems Installation and Operating Manual DOC | V4.0 | 2009.06
System Log / Event Log
The System Log field contains information about the operating status of the module and the
connection. You can save these messages automatically in a file (see Section 5.15 Advanced
Mode: LIVEPAGE Functions, page 40).
Events such as the triggering or end of alarms are shown in the Event Log field. You can save
these messages automatically in a file (see Section 5.15 Advanced Mode: LIVEPAGE Functions,
page 40).
1. If you want to delete the entries, click the delete icon in the top right-hand corner of the
relevant field.
2. If you want to view a detailed log, click the icon in the top right-hand corner of the
relevant field. A new window will open.
Audio Function (Audio Version Only)
Depending on the configuration, the module can send and receive audio signals. All users who
are connected by browsers receive the audio signals sent by the module.
6.3 Saving Snapshots
You can save individual images from the video sequence currently shown on the LIVEPAGE in
JPEG format on your computer's hard drive. The icon for recording single images is only
visible if the unit is configured to enable this process (see Section Allow snapshots, page 41).
You can save snapshots from each of the four cameras in the Quad View. The icons below the
camera images apply to the four camera images in the following sequence: top left, top right,
bottom left, bottom right.
X Click the icon. The image is saved at a resolution of 704 × 576 pixels (4CIF). The storage
location depends on the configuration of the module (see Section Path for JPEG and
MPEG files, page 41).
i
NOTICE!
It is not possible to send audio signals to the module.