Filter
Top Products
92 en | Operation VIP X1600 M4S
DOC | V4.0 | 2009.06 Installation and Operating Manual Bosch Security Systems
Image Selection
You can view the image from each camera separately on a full screen. Alternatively, you can
display the camera images from all four video inputs together (Quad View).
1. Click one of the tabs above the video image to view one or all of the camera images.
2. Click one of the tabs Stream 1, Stream 2 or
M-JPEG below the video image to toggle between the different displays of the camera
images. The selection applies to all camera images.
View Control
The options for controlling peripheral devices (for example a pan/tilt camera head or a dome
camera) are dependent on the unit type installed and on the configuration of the module.
If a controllable unit is configured and connected to the module, the controls for the
peripheral are displayed to the left of the video image.
1. To control a peripheral, click the appropriate controls.
2. Move the mouse cursor over the video image. Additional options for controlling
peripherals are displayed with the mouse cursor.
Digital I/O
The alarm icons Input 1 to Input 4 are for information purposes and indicate the status of an
alarm input: When an alarm is triggered, the corresponding icon lights up blue. The unit's
configuration determines whether the alarm is displayed, as well as additional details (see
Section 5.15 Advanced Mode: LIVEPAGE Functions, page 40).
Triggering Relay
You can switch connected units using the relays in the module (for example lights or door
openers).
X To activate this, click the icon for the corresponding relay next to the video image. The
icon will be red when the relay is activated.