Filter
Top Products
82 en | Configuration Using a Web Browser VIP X1600 M4S
DOC | V4.0 | 2009.06 Installation and Operating Manual Bosch Security Systems
Enable
To enable simultaneous data reception on several receivers you need to activate the multicast
function. To do this, check the box. You can then enter the multicast address.
Multicast address
Enter a valid multicast address for each stream from the relevant encoder (video input) to be
operated in multicast mode (duplication of the data streams in the network).
With the setting 0.0.0.0 the encoder for the relevant stream operates in multi-unicast mode
(copying of data streams in the unit). The module supports multi-unicast connections for up
to five simultaneously connected receivers.
Port
Assign a different port to each data stream if there are simultaneous data streams at the same
multicast address.
Enter the port address of the required stream here.
Streaming
Click the checkbox to activate multicast streaming mode for the relevant stream. An enabled
stream is indicated by a check mark.
Multicast packet TTL
You can enter a value to specify how long the multicast data packets are active on the
network. This value must be greater than one if multicast is to be run via a router.
5.41 Advanced Mode: JPEG Posting
You can save individual JPEG images on an FTP server at specific intervals. You can then
retrieve these images at a later date to reconstruct alarm events if required.
Image size
Select the resolution you wish the JPEG images to have:
– Small
176 × 144/120 pixels (QCIF)
i
NOTICE!
Duplication of data places a heavy demand on the module and can lead to impairment of the
image quality under certain circumstances.