Filter
Top Products
111
Playback
Remote Sensor Mode
Two remote sensor modes and an off setting are available to prevent interference from other Canon
wireless controllers being used nearby.
To change the remote sensor mode of the camcorder
Open the menu and select [SYSTEM SETUP/ ]. Select [WL.REMOTE], select a setting
option and close the menu.
To change the remote sensor mode of the wireless controller
While holding the REMOTE SET button pressed down, press and hold the ZOOM T
button for more than 2 seconds to change the wireless controller to mode 2.
To change the wireless controller to mode 1, press and hold the REMOTE SET and ZOOM W buttons
instead.
Make sure that the camcorder and wireless controller are set to the same mode. Display the
camcorder’s mode by pressing any button on the wireless controller (except the REMOTE SET
button) and set the wireless controller’s mode to the same mode. Change the batteries if the
wireless controller still does not work.
The wireless controller returns to mode 1 when you replace the batteries. Change the mode if
necessary.
COPY