Filter
Top Products
139
Additional Information
List of Messages (in alphabetical order)
Message Explanation
CARD ERROR A memory card error occurred. The camcorder cannot record or play back the image.
The error may be temporary. If the message disappears after 4 seconds and flashes
in red, turn the camcorder off, remove the card and reinsert the card. If changes to
green, you can continue recording/playback.
–
CARD FULL No remaining capacity on the memory card. Replace with another card or erase images. –
CHANGE THE BATTERY PACK Battery pack is exhausted. Replace or charge the battery pack. 16
CHECK THE HDV/DV INPUT DV cable is not connected, or the connected digital device is turned off. 86
CONDENSATION HAS BEEN DETECTED Condensation has been detected in the camcorder. 144
COPYRIGHT PROTECTED
DUBBING RESTRICTED
You attempted to dub a copyright protected tape. May also appear when an anomalous
signal is received during analog line-in recording, or during analog-digital conversion of a
copyright protected tape.
86
COPYRIGHT PROTECTED
PLAYBACK IS RESTRICTED
You attempted to play back a copyright protected tape.
86
HEADS DIRTY, USE CLEANING CASSETTE Video heads are dirty. Clean the video heads. 143
INCORRECT TAPE SPECIFICATION
PLAYBACK IS RESTRICTED
You attempted to play back a tape recorded in a standard different than the one to which
the camcorder is set.
–
INPUT SIGNAL NOT SUPPORTED You attempted to input a video signal incompatible with the camcorder (for example 720p). 86
NAMING ERROR The folder and file numbers have reached their maximum value. –
NO CARD Memory card is not inserted into the camcorder. 26
NO IMAGES No images are recorded on the memory card. –
PLAYBACK STD LOCKED INCOMPATIBLE
VIDEO INPUT
When the playback standard is already set in the camcorder, you attempted to input a
video signal in a standard different from that set.
86
PLAYBACK STD LOCKED
PLAYBACK IS RESTRICTED
When the playback standard is already set in the camcorder, you attempted to play back a
tape in a video standard different from that set.
107
REMOVE THE CASSETTE Camcorder stopped operating to protect the tape. Remove the cassette and reinsert it. 25
SET THE TIME ZONE, DATE AND TIME You have not set the time zone, date and time. This message appears each time you turn
the power on until you set the time zone, date and time.
28
TAPE END Tape reached the end. Rewind the tape or replace the cassette. –
THE CARD IS SET FOR ERASURE
PREVENTION
SD/SDHC memory card is set for erasure prevention. Replace the card or change the
position of the LOCK switch.
26
THE TAPE IS SET FOR ERASURE
PREVENTION
Cassette is protected. Replace the cassette or change the position of the protect switch.
142
UNIDENTIFIABLE IMAGE Image is not recorded with JPEG compression, or with a compression not compatible with
the camcorder, or the image file is corrupted.
–
COPY