Filter
Top Products
80
Activate the HD/SD SDI output and select the appropriate video output option (HD or SD).
1. Set the dial to .
2. Open the menu and select [SIGNAL SETUP]. Select [SDI OUTPUT] and set it to [ON] or
[ON(OSD)].
3. From the same [SIGNAL SETUP] submenu select [SDI SPEC.]. Select [AUTO] or
[SD LOCKED] to match the video output you wish to use.
4. Close the menu.
When [SDI OUTPUT] is set to [ON(OSD)], will appear on the screen and on-screen displays will
be included in the video signal output from the SDI terminal.
When [SDI OUTPUT] is set to [ON(OSD)]:
The on-screen displays included in the video output signal are determined by the display level
selected with the DISP. button ( 33). Markers (safety zone guide, level/grid markers, etc.) are
never included in the video signal output.
The [SIGNAL SETUP] [COMP.OUT] setting is not available.
Using the HD/SD COMPONENT OUT or VIEWFINDER COMPONENT OUT Terminal
Use the HD/SD COMPONENT OUT terminal to monitor the video that the camcorder is recording and use
the VIEWFINDER COMPONENT OUT terminal to monitor the picture on the viewfinder screen.
When using the HD/SD COMPONENT OUT terminal, select the appropriate component video signal
depending on the TV or monitor you connect.
Open the menu and select [SIGNAL SETUP]. Select [COMP.OUT], select a setting option
and close the menu.
2
SD
HD/SD
HD/SD
HD/SD
AUDIO
VIDEO
INPUT
Pb
Pr
Y
R
L
STV-290N Stereo
Video Cable* (supplied)
Signal flow
DTC-1000 Component Video Cable (supplied)
Open the terminal cover
Red
Blue
Green
Yellow
White
Red
* The audio signal is separate from the component video signal
Signal flow
COPY