96
1
2
3
4
5
6
7
8
9
Cover
PreliminaryNotesand
LegalInformation
Contents:
BasicOperations
AdvancedGuide
CameraBasics
SmartAuto
Mode
OtherShooting
Modes
PMode
Wi-FiFunctions
SettingMenu
Accessories
Appendix
Index
BasicGuide
PlaybackMode
Cover
AdvancedGuide
6
Wi-FiFunctions
• The following Windows settings are congured when you run the utility in step 2.
- Turn on media streaming.
This will enable the camera to nd the computer to access via Wi-Fi.
- Turn on network discovery.
This will enable the computer to nd the camera.
- Turn on ICMP (Internet Control Message Protocol).
This allows you to check the network connection status.
- Enable Universal Plug & Play (UPnP).
This will enable network devices to detect each other automatically.
•Some security software may prevent you from completing the settings as
described here. Check the settings of your security software.
Adding a Computer
Add a computer to your list of devices to connect to via Wi-Fi.
Follow these instructions when using a Wi-Fi Protected Setup (WPS)
compatible access point to establish a push-button connection.
If your access point is not WPS-compatible, establish a connection as
described in “Connecting to Access Points in the List” (=
98).
•WPS makes it easy to complete settings when connecting devices over Wi-Fi.
You can use either Push Button Conguration Method or PIN Method for
settings on a WPS supported device.
•Refer to the user guide provided with your access point to check if it supports
WPS.
•Be sure to also read the user guide included with your access point.
1 AccesstheWi-Fimenu.
Press the <o> button.
2 Chooseacomputer.
Press the <o><p><q><r> buttons to
choose [
], and then press the <m>
button.
3 Choose[AddaDevice].
Press the <o><p> buttons to choose
[Add a Device], and then press the <m>
button.
A list of detected access points will be
displayed in the [Select Network] screen.
4 Choose[WPSConnection].
Press the <o><p> buttons to choose
[WPS Connection], and then press the
<m> button.
5 Choose[PBCMethod].
Press the <o><p> buttons to choose
[PBC Method], and then press the <m>
button.
C OPY