Filter
Top Products
57
Snapshot Tutorial
7. Press the shutter button to shoot.
8. If you keep the shutter button depressed, the camera will shoot the
number of images you specified. Recording will stop if you release the
shutter button before the specified number of images is reached.
9. Save the CS images (page 62).
IMPORTANT!
• You cannot use the Triple Self-timer in combination with Flash CS.
NOTE
• The back lamp flashes red while the flash is charging. You will not be able to
perform further Flash CS shooting until charging is complete, which is indicated
when the back lamp stops flashing and goes out.
• When shooting with Flash CS, there may be times when a message appears telling
you to wait, because you have reached the limit of the flash. This is to protect the
flash from damage. You will be able to resume using flash after the message
disappears.
The number of consecutive images you can shoot is theoretically unlimited, as long
as there is memory available to store them. Also note that the maximum shooting
speed of Normal Speed CS is limited by the type of memory card you are using and
the camera setup.
1. In the REC mode, press [MENU].
2. Use [4] and [6] to select the “REC” tab.
3. Use [8] and [2] to select “CS” and then press [6].
4. Use [8] and [2] to select “Normal Speed CS”, and then press [SET].
Using Normal Speed Continuous Shutter