Filter
Top Products
2-6
Cisco Catalyst Blade Switch 3120 for HP Hardware Installation Guide
OL-12246-01
Chapter 2 Switch Installation
Installing the Switch Module in the Blade Enclosure
Installing the Switch Module in the Blade Enclosure
Before you install the switch module in the blade enclosure, consider these points:
• Review and become familiar with the safety guidelines in the Regulatory Compliance and Safety
Information for the Cisco Catalyst Blade Switch 3000 Series for HP that accompanies this guide.
• Review and become familiar with the safety guidelines in the HP BladeSystem enclosure setup and
installation guide.
• Review and become familiar with the temperature, power, and grounding requirements specified in
the HP BladeSystem enclosure setup and installation guide.
Warning
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Statement 1030
Caution To prevent electrostatic-discharge (ESD) damage when installing switch modules, follow your normal
board and component handling procedures.
When you install a switch module, you do not need to power down the blade enclosure.
Follow these steps to install the switch module in the blade enclosure:
Step 1 If you have not already done so, touch the static-protective package that contains the switch module to
an unpainted metal part of the blade enclosure for at least 2 seconds.
Step 2 Remove the switch module from its static-protective package.
Step 3 Remove the interconnect blank from the bay where you plan to install the switch module, if one is
present, and install the switch module. (See
Figure 2-2.)