Filter
Top Products
C-2
Cisco Catalyst Blade Switch 3120 for HP Hardware Installation Guide
OL-12246-01
Appendix C Configuring the Switch with the CLI-Based Setup Program
Accessing the CLI Through the Console Port
Complete these steps:
Step 1 Connect one end of the console cable to the switch module console port. Connect the other end of the
cable to the serial port of the computer that is running the terminal emulation application. (See
Figure C-1.)
You can use the mdix auto interface configuration command in the CLI to enable the automatic
medium-dependent interface crossover (auto-MDIX) feature. When the auto-MDIX feature is enabled,
the switch module detects the required cable type for copper Ethernet connections and configures the
interfaces accordingly. Therefore, you can use either a crossover or a straight-through cable for
connections to a copper 10/100/1000 or 1000BASE-T SFP module port on the switch module, regardless
of the type of device on the other end of the connection.
For configuration information for this feature, refer to the switch module software configuration guide
or the switch module command reference on Cisco.com.