Filter
Top Products
D14908.01 SX20 Administrator Guide (TC5.1) | 2012 FEBRUARY | © 2012 Cisco Systems, Inc. All rights reserved. www.cisco.com
16
Cisco TelePresence SX20 Quick Set
ADMINISTRATOR GUIDE
Addressinputfield
Call Control
Placingacall
You can use the Call Control page of the web interface to
initiate a call.
NOTE: Even if the web interface is used to initiate the call it
is the video system (display, microphones and loudspeakers)
that is used for the call; not the PC running the web interface.
Callingsomeone
Enter one or more characters in the address input field until
the name you want to call appears in the dynamic search list
or, enter the complete name or number. Then press Dial.
Press End all to disconnect the call.
Callingmorethanone
A point-to-point video call (a call involving two parties only)
may be expanded to include more participants if your system
supports the optional built-in MultiSite feature (up to four
participants, yourself included). The call will then become a
video conference.
When in a call, enter the name or number of the next
participant in the address input field, and then press Dial.
Press End all to terminate the entire conference.
To disconnect just one of the participants, press the
button for that participant.
Sharingcontents
Select a Presentation Source from the drop down list, and
press the Start Presentation button.
Normally a PC is used as presentation source, but other
options may be available depending on your system setup.
To stop the content sharing, press the Stop Presentation
button that becomes visible while sharing.
Introduction
Table of contents
Web interface
Advanced settings
Appendices
Web interface