Filter
Top Products
D14908.01 SX20 Administrator Guide (TC5.1) | 2012 FEBRUARY | © 2012 Cisco Systems, Inc. All rights reserved. www.cisco.com
31
Cisco TelePresence SX20 Quick Set
ADMINISTRATOR GUIDE
TheAudiosettings
AudioMicrophonesMuteEnabled
Determine whether audio-mute is allowed or not. The default value is True.
Requiresuserrole: ADMIN
Valuespace: <True/InCallOnly>
True: Muting of audio is always available.
InCallOnly: Muting of audio is only available when the device is in a call. When Idle it is not
possible to mute the microphone. This is useful when an external telephone service/audio
system is connected via the codec and is to be available when the codec is not in a call.
When set to InCallOnly this will prevent the audio-system from being muted by mistake.
Example: Audio Microphones Mute Enabled: True
AudioSoundsAndAlertsKeyTonesMode
The system can produce a sound every time a key on the remote control is pressed.
Requiresuserrole: USER
Valuespace: <On/Off>
On: There will be a sound indicator when pressing keys on the remote control.
Off: The remote control Key Tones is switched off.
Example: Audio SoundsAndAlerts KeyTones Mode: Off
AudioSoundsAndAlertsRingTone
Select the ring tone for incoming calls.
Requiresuserrole: USER
Valuespace: <Marbles/IceCrystals/Polaris/Alert/Discreet/Fantasy/Jazz/
Nordic/Echo/Rhythmic>
Range: Select a tone from the list of ring tones.
Example: Audio SoundsAndAlerts RingTone: Jazz
AudioSoundsAndAlertsRingVolume
Sets the ring tone volume for an incoming call.
Requiresuserrole: USER
Valuespace: <0..100>
Range: The value goes in steps of 5 from 0 to 100 (from -34.5 dB to 15 dB). Volume 0 = Off.
Example: Audio SoundsAndAlerts RingVolume: 50
AudioVolume
Set the volume on the loudspeaker.
Requiresuserrole: USER
Valuespace: <0..100>
Range: The value goes in steps of 5 from 0 to 100 (from -34.5 dB to 15 dB). Value 0 = Off.
Example: Audio Volume: 70
Introduction
Table of contents
Web interface
Advanced settings
Appendices
Advanced settings