Cisco Systems CTSATPSX204XK9 Security Camera User Manual


  Open as PDF
of 80
 
D14908.01 SX20 Administrator Guide (TC5.1) | 2012 FEBRUARY | © 2012 Cisco Systems, Inc. All rights reserved. www.cisco.com
66
Cisco TelePresence SX20 Quick Set
ADMINISTRATOR GUIDE
TheExperimentalsettings
The Experimental settings are beta preview features and can be used 'as is'. They are not fully
documented.
NOTE: The Experimental settings are likely to change without further notice.
ExperimentalAudioEcReferenceDelay
NOTE: This Experimental command can be used 'as is' and will not be further documented. The
Experimental settings WILL change.
Requiresuserrole: ADMIN
Valuespace: <0..300>
Example: Experimental Audio EcReferenceDelay: 0
ExperimentalCapsetFilter
NOTE: This Experimental command can be used 'as is' and will not be further documented. The
Experimental settings WILL change.
Requiresuserrole: ADMIN
Valuespace: <S: 0, 100>
Example: Experimental CapsetFilter: ""
ExperimentalCapsetReduction
NOTE: This Experimental command can be used 'as is' and will not be further documented. The
Experimental settings WILL change.
Requiresuserrole: ADMIN
Valuespace: <Auto/Reduced>
Example: Experimental CapsetReduction: Auto
ExperimentalConference[1..1]PacketLossResilienceForwardErrorCorrection
NOTE: This Experimental command can be used 'as is' and will not be further documented. The
Experimental settings WILL change.
Will enable ForwardErrorCorrection (RFC5109) mechanism as part of the PacketLossResilience
mechanism. Default value is On.
On: Forward error correction will be used as part of the PacketLossResilience mechanism.
Off: Forward error correction will NOT be used as part of the PacketLossResilience mechanism.
Requiresuserrole: ADMIN
Valuespace: <On/Off>
Example: Experimental Conference 1 PacketLossResilience
ForwardErrorCorrection: On
ExperimentalConference[1..1]PacketLossResilienceRateAdaption
NOTE: This Experimental command can be used 'as is' and will not be further documented. The
Experimental settings WILL change.
Will use the a RateAdaption algorithm adapted to the PacketLossResilience mechanism. Default
value is On.
Requiresuserrole: ADMIN
Valuespace: <On/Off>
On: RateAdaption will be used as part of the PacketLossResilience mechanism.
Off: RateAdaption will NOT be used as part of the PacketLossResilience mechanism.
Example: Experimental Conference 1 PacketLossResilience RateAdaption: On
ExperimentalConference[1..1]MultistreamMode
NOTE: This Experimental command can be used 'as is' and will not be further documented. The
Experimental settings WILL change.
Requiresuserrole: ADMIN
Valuespace: <Off/On>
Example: Experimental Conference 1 Multistream Mode: Off
ExperimentalConference[1..1]MultistreamInputCount
NOTE: This Experimental command can be used 'as is' and will not be further documented. The
Experimental settings WILL change
Requiresuserrole: ADMIN
Valuespace: <1..4>
Example: Experimental Conference 1 Multistream InputCount: 1
ExperimentalConference[1..1]MultistreamOutputCount
NOTE: This Experimental command can be used 'as is' and will not be further documented. The
Experimental settings WILL change
Requiresuserrole: ADMIN
Valuespace: <1..4>
Example: Experimental Conference 1 Multistream OutputCount: 1
Introduction
Table of contents
Web interface
Advanced settings
Appendices
Advanced settings
 previous next