Filter
Top Products
D14908.01 SX20 Administrator Guide (TC5.1) | 2012 FEBRUARY | © 2012 Cisco Systems, Inc. All rights reserved. www.cisco.com
55
Cisco TelePresence SX20 Quick Set
ADMINISTRATOR GUIDE
SIPProfile[1..1]Proxy[1..4]Address
The Proxy Address is the manually configured address for the outbound proxy. It is possible to
use a fully qualified domain name, or an IP address. The default port is 5060 for TCP and UDP
but another one can be provided. If Outbound is enabled, multiple proxies can be addressed.
Requiresuserrole: ADMIN
Valuespace: <S: 0, 255>
Format: Compact string with a maximum of 255 characters. An IP address that contains
letters (192.a.2.0) or unvalid IP addresses (192.0.1234.0) will be rejected.
Example: SIP Profile 1 Proxy 1 Address: ""
SIPProfile[1..1]Proxy[1..4]Discovery
Select if the SIP Proxy address is to be obtained manually or by using Dynamic Host
Configuration Protocol (DHCP).
Requiresuserrole: ADMIN
Valuespace: <Auto/Manual>
Auto: When Auto is selected, the SIP Proxy address is obtained using Dynamic Host
Configuration Protocol (DHCP).
Manual: When Manual is selected, the manually configured SIP Proxy address will be used.
Example: SIP Profile 1 Proxy 1 Discovery: Manual
SIPProfile[1..1]Type
Enables SIP extensions and special behaviour for a vendor or provider.
Requiresuserrole: ADMIN
Valuespace: <Standard/Alcatel/Avaya/Cisco/Microsoft/Nortel>
Standard: To be used when registering to standard SIP Proxy (tested with Cisco
TelePresence VCS and Broadsoft)
Alcatel: To be used when registering to Alcatel-Lucent OmniPCX Enterprise. NOTE: This
mode is not fully supported.
Avaya: To be used when registering to Avaya Communication Manager. NOTE: This mode is
not fully supported.
Cisco: To be used when registering to Cisco Unified Communication Manager.
Microsoft: To be used when registering to Microsoft LCS or OCS. NOTE: This mode is not
fully supported.
Nortel: To be used when registering to Nortel MCS 5100 or MCS 5200 PBX. NOTE: This
mode is not fully supported.
Example: SIP Profile 1 Type: Standard
Introduction
Table of contents
Web interface
Advanced settings
Appendices
Advanced settings