Cisco Systems CTSATPSX204XK9 Security Camera User Manual


 
D14908.01 SX20 Administrator Guide (TC5.1) | 2012 FEBRUARY | © 2012 Cisco Systems, Inc. All rights reserved. www.cisco.com
22
Cisco TelePresence SX20 Quick Set
ADMINISTRATOR GUIDE
Theauditcertificatelist
If you want to use the ExternalSecure audit logging mode,
you must upload a list of trusted audit certificates to the video
conference system. This list must cover all audit servers that
your system shall trust.
In the ExternalSecure audit logging mode audit logging
information will only be sent to entities holding a valid audit
certificate.
NOTE: You must always upload the audit certificate list before
enabling secure audit logging.
Aboutauditlogging
Audit logging records all sign in activity and configuration
changes on the system.
Audit logging is disabled by default. You can enable audit
logging using the on-screen menu or the web interface.
1.Uploadtheauditcertificatelist
To install the audit certificate, you will
need:
• Audit list file ( .PEM format)
Contact your system administrator to
obtain the required file.
i. Press Browse... and locate the file with
the audit list file (.PEM format).
ii. Press Upload to store the certificate on
your system.
2.Enablesecureauditlogging
When you have uploaded the audit
certificate list you must enable secure
audit logging:
i. Select Advanced Configuration under
the Configuration tab. Then select
Security in the list of settings groups
on the left hand side.
ii. Enter the Address and Port number of
the audit server.
iii. Select ExternalSecure from the
Logging Mode drop down list.
Maintenance
Software Upgrade
Certificate Management
Audit Certificate
User Administration
Restart
Factory Reset
i
ii
iii
Introduction
Table of contents
Web interface
Advanced settings
Appendices
Web interface