Filter
Top Products
61
Recording
E
When Connecting to the XLR terminals
1. Connect a microphone to the XLR terminals.
To supply a microphone with phantom power, set the +48V switch to ON. Make sure to connect the
microphone first, before turning on the phantom power. Keep the microphone connected when turning off
the phantom power.
2. Set the INPUT SELECT switch to REAR.
3. Set the REC CH SELECT switch to CH1 or CH1·CH2.
4. Set the LINE/MIC switch to the appropriate position depending on the input signal.
The setting of the LINE/MIC switch applies simultaneously to channels 1 and 2.
5. If necessary, turn on the microphone attenuator (20 dB) by setting the MIC ATT. switch
to ATT.
The microphone attenuator will only be effective when the LINE/MIC switch is set to MIC.
6. For 12dB gain-up: Open the menu and select [AUDIO SETUP]. Select [R-XLR GAINUP],
set it to [12dB] and close the menu.
When connecting a microphone that does not support phantom power, make sure to set the +48V
switch to OFF. Otherwise the microphone may be damaged.
Input terminal Position of the REC CH SELECT switch Recorded channel
CH1/3 CH1 Channel 1
CH1·CH2 Channel 1+ Channel 2
CH2/4 CH1 Channel 2
CH1·CH2 – – –