Filter
Top Products
21D-Link DCS-5230 User Manual
Section 3 - Configuration
Setting up a Wireless Connection with WPS
If your wireless access point or router supports push-button Wireless Protected Setup
(WPS), you can quickly congure your wireless network and camera without using the
camera’s web interface.
After plugging the power adapter to your camera and the front status LED lights up, hold
down the WPS button on the back of the camera for 3 seconds. After pressing the button,
it should start ashing blue.
Now press the WPS button on your router or access point within 1 minute to activate WPS
and allow your devices to automatically congure a wireless connection. After WPS is
successfully activated, the WPS LED on your camera will stop ashing, and will light up
solid blue, then reboot.
Note: On some routers/access points, you may need to enter the web interface to activate
WPS. Consult your product’s user manual for further assistance.
WPS Button
Press this button to establish a WPS connection.