D-Link DCS-5230 Security Camera User Manual


  Open as PDF
of 91
 
35D-Link DCS-5230 User Manual
Section 3 - Configuration
JPEG Quality:
RTSP URL:
Night Mode:
Enable Night Mode:
Shutter:
Enable Speaker:
Volume:
Enable Microphone:
Volume:
This sets the JPEG quality of any manual snapshots you take when this video prole is selected.
This setting allows you to set a sufx for your camera’s RTSP URL, so you can view your camera’s video with
this video prole’s settings. For example, if you enter “mpeg4” as your RTSP URL setting and your camera’s
IP is 192.160.0.30, you can view your camera’s video with these settings through 192.160.0.20/mpeg4 .
Note: Video Prole 3 is always set to MJPEG as the Encode Type to ensure that at least one of the Video
Proles are viewable by non-IE browsers. Video Prole 4 is for mobile devices only, and always uses MPEG-4
as the Encode Type.
Night mode allows the camera to use a longer shutter speed when the camera is in a low-light environment. If
the camera is in an area where there is sufcient lighting, Night Mode will not affect the video stream.
Check this box to enable Night Mode.
This sets the longest shutter speed Night Mode will use when Night Mode is enabled and the camera is viewing
a low-light scene.
Checking this box will enable you to send audio to an external speaker (not included) attached to the external
speaker jack of your camera. This will allow you to speak with another person through your camera.
This sets the volume level of the external speaker.
Checking this box will enable you to listen to audio picked up by the camera’s microphone. This will allow you
to hear what is happening near your camera.
This sets the volume level of the incoming audio.
Note: Higher frame size, frame rate and bit rates will give you better video quality, but they will also require
more network bandwidth. For best viewing results on a mobile phone, we suggest setting the frame rate to 5
fps and bit rate to 20 Kbps.
After making any changes, click the Save Settings button to save your changes, or click the Don’t Save
Settings button to discard your changes.
 previous next