Filter
Top Products
31D-Link DCS-5230 User Manual
Section 3 - Configuration
To set up your IP camera’s wireless network
interface settings, enable Wireless Settings
in this window rst. Then continue the further
conguration next.
Clicking this button will scan for available wireless
networks. After scanning, you can use the drop-
down box to select an available wireless network,
and related information (SSID, Wireless Mode,
Channel, Authentication, Encryption) will be
automatically lled in for you.
Enter the SSID of the wireless access point you
wish to use.
Use the drop-down box to select the mode of the
wireless network you wish to connect to. Infrastructure is normally used to connect to an access point or router.
Ad-Hoc is usually used to connect directly to another computer.
If you are using Ad Hoc mode, select the channel of the wireless network you wish to connect to, or select Auto.
Select the authentication you use on your wireless network - Open, Shared(WEP), WPA-PSK, or WPA-PSK2.
If you use WPA-PSK or WPA-PSK2 authentication, you will need to specify whether your wireless network
uses TKIP or AES encryption. If you use Open or Shared authentication, this setting will be automatically set
for you.
If you use WEP, WPA-PSK, or WPA-PSK2 authentication, enter the Key (also known as password) used for
your wireless network.
After making any changes, click the Save Settings button to save your changes, or click the Don’t Save
Settings button to discard your changes.
Wireless Setup
Enable Wireless:
Site Survey:
SSID:
Wireless Mode:
Channel:
Authentication:
Encryption:
Key: