Filter
Top Products
34D-Link DCS-5230 User Manual
Section 3 - Configuration
You can set the camera’s sensor output to VGA quality
(640x480), XGA quality (1024x768), or SXGA quality
(1280x1024).
Note: When using SXGA mode, please note that motion
detection and motion triggered snapshots will be disabled
and that recordings will be done at a maximum of Medium
resolution.
You can set up 4 different video proles, which allow you
customize how you view your camera’s video stream.
This sets the video codec used for the video stream. You
can choose MPEG-4 or MJPEG(JPEG). IE browsers can
view both MPEG-4 and MJPEG video streams, and non-
IE browsers can only view MJPEG video streams.
This sets the display resolution of the video stream. If
the Resolution is different than the Sensor Output size,
the video will be shrunk or enlarged to the Resolution
size you set here.
This sets the target number of frames per second (FPS)
for the video stream. Higher framerates will provide
smoother video.
This sets the target bitrate of the video stream. Higher
bitrates will provide better quality video. When the Encode Type is set to MJPEG, you cannot change the
bps setting. Also, available bps settings may change depending on what the Encode Type, Sensor Output,
Resolution, and FPS settings are set to.
Click the Audio and Video button on the left side of the Setup screen to access audio and video settings that affect
how the audio and video appears.
Audio and Video
Sensor Output:
Video Profile:
Encode Type:
Resolution:
FPS:
bps: