Filter
Top Products
45D-Link DCS-5230 User Manual
Section 3 - Configuration
Check this box to enable the D/O port.
When checked, the D/O port will send a signal
whenever motion is detected by the camera.
(When motion detection has been enabled)
When checked, the D/O port will send a signal
whenever a signal is detected on the Digital In
(D/I) port.
Note: If the camera is set to SXGA mode in Audio
and Video, Motion Detection is disabled.
Digital Output
Enable D/O:
Motion Detection:
D/I:
This screen allows you to enable the Digital Out (D/O) port, and allows you to select what events will trigger the Digital
Out signal.