Filter
Top Products
68
4
5
Press the Shutter button down fully to start
recording.
The brightness and color of the screen shown during movie
recording may differ from those shown before recording
begins.
Do not need to hold down the Shutter button.
Pressing the Shutter button down fu y ocks the
focus but the exposure and white balance vary
! automatically according to the scene being shot
A counter appears in the top-right corner of the
screen during recording shows the remaining time.
_lf the brightness of the subject changes during movie
recording, the sound of lens operation may be recorded.
t Some wind noise may be recorded in shots taken outdoors.
,;t When the remaining time runs out, recording automatically
ends and the movie issaved onto the media.
6
Press the Shutter button during recording to end
recording.
If shooting is stopped immediately after it begins, abuto 1
second of movie is recorded onto the media.
_ Notes on using Microdrives for movie shooting _
If the camera's internal temperature rises too high, movie shooting automatically stops to protect the
media. Because Microdrives tend to generate heat (for mechanical reasons), long periods of
continuous movie shooting may not be possible when the ambient temperature is high. As a general
guide to shooting times, you can shoot movies for around 20 minutes at an ambient temperature of
+30°C/+86°F and for around 30 minutes at +25°C/+77°F.
PLEASESTOP
MOVIE RECORDING!
®
[]
If the camera's internal temperature rises during shooting, a message appears saying
"MICRODRIVE IS OVERHEATING. MOVIE RECORDING WILL AUTOMATICALLY STOP SOON".
(_ This then changes to "PLEASE STOP MOVIE RECORDINGF. If you continue shooting, the movie is
automatically saved and the camera shuts down.
If you then immediately try to start shooting again, "MOVIE RECORDING HAS STOPPED CANNOT
RESTART A WHILE" is displayed and you cannot start shooting. Switch the camera off and do not
use it for roughly 30 minutes until it has cooled down. Note that you can still shoot still images during
this period.
_t Becausethe Microddve ishot just after a movie is shot,do not removethe Microddveimmediately.
+,.......................................................................................................................................................................................................................................................................................................................................................................................
!
Set the Power switch to "[_".
Press "_11"or "1_."to select the movie file.
Movies cannot be played back using multi=frame playback.
Use the "DISP" button to select single=frame playback.
2
Press "V" to play the movie,
@The screen shows the playback time and a
playback progress bar.
Take care not to block the speaker.
_t When the sound is difficult to hear, adjust the volume
(-P.22).
_;t If the subject of the shot is very bright, white vertical streaks
or black horizontal streaks may appear in the image during
playback. This is normal and does not indicate a fault.
• Playing Back Movies
Control Description
Playback begins. Playback automatically stopswhen the end of
Playback/Pause the movie is reached. During playback, this button pauses the
movie.
_ Stopsplayback.
Stop _ =,_Press "_1"or "lb." while movieplayback isstopped togo back
to theprevious file or advanceto thenext file respectively.
Fastforward/ Press "_1"or "lb."during playbacktoskip forwardsor backwards
Rewind through the movie.
Rewind _"_ Fastforward
_1_1_ Press "_1"or "lb."when the movieis paused,the movie advances
Skipplayback _ or goesback oneframe.
When paused
@ Playing movie files @ .,,
• You may not be able to play some movie files recorded on other cameras.
• To play back movie files on a computer, save the movie file on the media to the computer's hard disk
and then play back the saved file.
69