Filter
Top Products
moveboard(8)
System Administration 79
OPERANDS The following operand is supported:
EXTENDED
DESCRIPTION
■ When the command is executed, a prompt to confirm execution of the command
with the specified options is displayed. Enter "y" to execute the command or "n"
to cancel the command.
■ If '-c configure' is specified when either of the following conditions apply to
the domains, the XSB is configured in the domain configuration:
■ The operating systems of both the source and destination domains are
running.
■ The operating system of the destination domain is running even though the
source domain is powered off.
■ If '-c assign' is specified when either of the following conditions apply to the
domains, the XSB is assigned to the domain configuration:
■ The operating system of the source domain is running.
■ The source domain is powered off
■ If '-c reserve' is specified when either the domain power of the move source
has been turned off or the operating system is not running, the XSB is
immediately disconnected from the domain of the move source and assigned to
the domain of the move destination
■ Moving the XSB involves the following internal operations and therefore
command execution may take time.
■ Disconnecting the hardware resource of the system board from the operating
system
■ Running a hardware diagnosis on the system board when connecting it
■ See the setdcl(8) and showdcl(8) commands for DCL.
EXAMPLES
EXAMPLE 1 Disconnects XSB#00-0 from the current domain and attaches it to domain
ID 1.
xsb Specifies the XSB number to be moved. Multiple xsb operands
are permitted, separated by spaces. The following xsb form is
accepted:
x–y
where:
x An integer from 00–15.
y An integer from 0–3.
XSCF> moveboard -d 1 00-0