Filter
Top Products
testsb(8)
System Administration 379
NAME testsb - perform an initial diagnosis of the specified physical system board (PSB)
SYNOPSIS testsb [[-q] -{y|n}][-m diag=mode] location
testsb -v [ -y|-n][-m diag=mode] location
testsb -h
DESCRIPTION testsb(8) command performs an initial diagnosis of the specified PSB.
The configuration of the PSB and operation of each device mounted on the PSB are
checked. After the diagnostics, the result is displayed. The PSB must not be
configured in the domain, or the domain in which the PSB configured must be
powered off.
The result also can be seen in ‘Test’ and ‘Fault’ displayed by showboards(8)
command.
Privileges You must have platadm or fieldeng privileges to run this command.
Refer to setprivileges(8) for more information.
OPTIONS The following options are supported:.
OPERANDS The following operand is supported:
EXTENDED
DESCRIPTION
■ When the system board (XSB: eXtended System Board) belonging to the specified
PSB is in any status below, the testsb(8) command results in an error.
■ XSB is installed in the domain and this domain is in operation.
-h Displays usage statement. When used with other options or
operands, an error occurs.
-m diag=mode Specifies the diagnostic level of initial diagnosis. One of the
values shown below can be specified:
min Normal (default)
max Maximum
-n Automatically answers 'n' (no) to all prompts.
-q Suppresses all messages to stdout, including prompts.
-v Displays a detailed message of initial diagnosis.
-y Automatically answers 'y' (yes) to all prompts.
location Specifies only one PSB number. An integer from 00–15 can be
specified.